Steel tube, galvanized 1"

This grooved cable drum ensures friction free, well-ordered winding and therefore a smooth movement of driving cable in shading systems .Two-halves model of the drum makes it possible to fasten it onto drive shaft subsequently. The two halves are connected quick and easy with a hose clamp and then installed onto the drive shaft with a headless screw.The cable drum is made of high-impact resistant plastic, that is friendly to cables and therefore increases their durability. Can be used with cords with a diameter up to 3 mm For 34 mm drive shaftsCapacity of cable drum: up to 5,70 m

This grooved cable drum ensures friction free, well-ordered winding and therefore a smooth movement of driving cable in shading systems .Two-halves model of the drum makes it possible to fasten it onto drive shaft subsequently. The two halves are connected quick and easy with U-bolt. To install the drum onto the drive shaft a headless screw is needed.The cable drum is made of high-impact resistant plastic, that is friendly to cables and therefore increases their durability. Can be used with cords with a diameter up to 3 mm For 34 mm drive shaftsCapacity of cable drum: up to 5,70 mMaterial: Cable drum: High impact resistant plasticU-Bolt: Galvanized steel

This offset bearing has been developed for suspended shading systems with gable end drive. It brings the drive shaft to an optimal position and as a support point enables its rotation. The product has been built to hold trailing load. Material: High impact reistant plastic For mounting you will need the following parts: - M 8 x 70 bolt - M8 nyloc nut

Our vertical bearing shaft supports 1" allows to set the drive shaft as close as possible to the gable end. In such a construction the shading screens do not set against the truss , but lay either over( in suspended system) or below ( in lay- flat system) the square tube, covering the whole area up to the gable end. The dalay of screens is basically not needed.The drive shaft can easily and quickly be pre-assembled on the ground. So dangerous, time-consuming works underneath the roof can be avoided.The bearings are attached onto the square tubes and locked with locking screws. If needed, they can be moved

Application: Joining 34 mm steel tubes in drive shafts Material: Hot-dip galvanized steel for superior strength and corrosion resistance Installation: Screwed together using included M8x50 bolts Highlight: Greater stability and longevity compared to welded joints Packaging Unit: 25 sets 1" Steel Tube Clamp Connectors incl. M8x50 Screws provide a secure and reliable connection for 34 mm steel tubes in drive shaft assemblies. Unlike welded joints, these clamp connectors offer improved durability and structural integrity. Each set includes M8x50 screws for quick installation. Thanks to the hot-dip galvanized finish, the connectors offer excellent corrosion protection, making them well-suited for long-term use in challenging environments.