4 bearing shaft support 1" vertical - Gable drive - PU = 20 pcs
Product information "4 bearing shaft support 1" vertical - Gable drive - PU = 20 pcs"
Our vertical bearing shaft supports 1" allows to set the drive shaft as close as possible to the gable end. In such a construction the shading screens do not set against the truss , but lay either over( in suspended system) or below ( in lay- flat system) the square tube, covering the whole area up to the gable end. The dalay of screens is basically not needed.
The drive shaft can easily and quickly be pre-assembled on the ground. So dangerous, time-consuming works underneath the roof can be avoided.
The bearings are attached onto the square tubes and locked with locking screws. If needed, they can be moved
The drive shaft can easily and quickly be pre-assembled on the ground. So dangerous, time-consuming works underneath the roof can be avoided.
The bearings are attached onto the square tubes and locked with locking screws. If needed, they can be moved
Skip product gallery
Customers who bought this item also bought:
Support plate Fiberlane 1" - Height: 100 mm - Lower edge to middle of drive shaft 62 mm
2,20
€
/ 1
Height (mm):
100
Steel tube galvanized, narrowed, 1'' / 2,5mm / L= 6,50 m
41,80
€
/ 1
PU:
loose
Variants from
36,35
€
*